Re: [RFC PATCH] mm: only set fault addrsss' access bit in do_anonymous_page

[Kiryl Shutsemau <kirill@shutemov.name>]

On Tue, Feb 10, 2026 at 12:34:56PM +0800, Wenchao Hao wrote:
> When do_anonymous_page() creates mappings for huge pages, it currently sets
> the access bit for all mapped PTEs (Page Table Entries) by default.
> 
> This causes an issue where the Referenced field in /proc/pid/smaps cannot
> distinguish whether a page was actually accessed.
> 
> So here introduces a new interface, set_anon_ptes(), which only sets the
> access bit for the PTE corresponding to the faulting address. This allows
> accurate tracking of page access status in /proc/pid/smaps before memory
> reclaim scan the folios.
> 
> During memory reclaim: folio_referenced() checks and clears the access bits
> of PTEs, rmap verifies all PTEs under a folio. If any PTE mapped subpage of
> folio has access bit set, the folio is retained during reclaim. So only
> set the access bit for the faulting PTE in do_anonymous_page() is safe, as
> it does not interfere with reclaim decisions.

We had similar discussion about faultaround and briefly made it produce
old ptes, but it caused performance regression as old ptes require
additional pagewalk to set accessed bit on touch. It got reverted,
but arch can opt-in for setting up old ptes for non-fault address.

See commits:

5c0a85fad949 ("mm: make faultaround produce old ptes")
315d09bf30c2 ("Revert "mm: make faultaround produce old ptes"")
46bdb4277f98 ("mm: Allow architectures to request 'old' entries when prefaulting")

-- 
  Kiryl Shutsemau / Kirill A. Shutemov