Re: [PATCH v2 2/2] arm: mm: support ARCH_MMAP_RND_BITS.

[Daniel Cashman <dcashman@android.com>]

On 11/08/2015 07:47 PM, Michael Ellerman wrote:
> On Fri, 2015-11-06 at 12:52 -0800, Kees Cook wrote:
>> On Thu, Nov 5, 2015 at 10:44 AM, Daniel Cashman <dcashman@android.com> wrote:
>>> On 11/04/2015 10:30 AM, Daniel Cashman wrote:
>>>> On 11/3/15 3:21 PM, Kees Cook wrote:
>>>>> On Tue, Nov 3, 2015 at 3:14 PM, Daniel Cashman <dcashman@android.com> wrote:
>>>>>> On 11/03/2015 11:19 AM, Kees Cook wrote:
>>>>>>> Do you have patches for x86 and arm64?
>>>>>>
>>>>>> I was holding off on those until I could gauge upstream reception.  If
>>>>>> desired, I could put those together and add them as [PATCH 3/4] and
>>>>>> [PATCH 4/4].
>>>>>
>>>>> If they're as trivial as I'm hoping, yeah, let's toss them in now. If
>>>>> not, skip 'em. PowerPC, MIPS, and s390 should be relatively simple
>>>>> too, but one or two of those have somewhat stranger calculations when
>>>>> I looked, so their Kconfigs may not be as clean.
>>>>
>>>> Creating the patches should be simple, it's the choice of minimum and
>>>> maximum values for each architecture that I'd be most concerned about.
>>>> I'll put them together, though, and the ranges can be changed following
>>>> discussion with those more knowledgeable, if needed.  I also don't have
>>>> devices on which to test the PowerPC, MIPS and s390 changes, so I'll
>>>> need someone's help for that.
>>>
>>> Actually, in preparing the x86 and arm64 patches, it became apparent
>>> that the current patch-set does not address 32-bit executables running
>>> on 64-bit systems (compatibility mode), since only one procfs
>>> mmap_rnd_bits variable is created and exported. Some possible solutions:
>>
>> How about a single new CONFIG+sysctl that is the compat delta. For
>> example, on x86, it's 20 bits. Then we don't get splashed with a whole
>> new set of min/maxes, but we can reasonably control compat?
> 
> Do you mean in addition to mmap_rnd_bits?
> 
> So we'd end up with mmap_rnd_bits and also mmap_rnd_bits_compat_delta?
> (naming TBD)
> 
> If so yeah I think that would work.
> 
> It would have the nice property of allowing you to add some more randomness to
> all processes by bumping mmap_rnd_bits. But at the same time if you want to add
> a lot more randomness to 64-bit processes, but just a bit (or none) to 32-bit
> processes you can also do that.

I may be misunderstanding the suggestion, or perhaps simply too
conservative in my desire to prevent bad values, but I still think we
would have need for two min-max ranges.  If using a single
mmap_rnd_bits_compat value, there are two approaches: to either use
mmap_rnd_bits for 32-bit applications and then add the compat value for
64-bit or the opposite, to have mmap_rnd_bits be the default and
subtract the compat value for the 32-bit applications.  In either case,
the compat value would need to be sensibly bounded, and that bounding
depends on acceptable values for both 32 and 64 bit applications.

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@kvack.org.  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>