From: Zhenhua Huang <quic_zhenhuah@quicinc.com>
To: <anshuman.khandual@arm.com>, <catalin.marinas@arm.com>
Cc: <will@kernel.org>, <ardb@kernel.org>, <ryan.roberts@arm.com>,
<mark.rutland@arm.com>, <joey.gouly@arm.com>,
<dave.hansen@linux.intel.com>, <akpm@linux-foundation.org>,
<chenfeiyang@loongson.cn>, <chenhuacai@kernel.org>,
<linux-mm@kvack.org>, <linux-arm-kernel@lists.infradead.org>,
<linux-kernel@vger.kernel.org>, <quic_tingweiz@quicinc.com>,
Zhenhua Huang <quic_zhenhuah@quicinc.com>,
<stable@vger.kernel.org>
Subject: [PATCH v6] arm64: mm: Populate vmemmap/linear at the page level for hotplugged sections
Date: Thu, 13 Feb 2025 15:57:03 +0800 [thread overview]
Message-ID: <20250213075703.1270713-1-quic_zhenhuah@quicinc.com> (raw)
On the arm64 platform with 4K base page config, SECTION_SIZE_BITS is set
to 27, making one section 128M. The related page struct which vmemmap
points to is 2M then.
Commit c1cc1552616d ("arm64: MMU initialisation") optimizes the
vmemmap to populate at the PMD section level which was suitable
initially since hot plug granule is always one section(128M). However,
commit ba72b4c8cf60 ("mm/sparsemem: support sub-section hotplug")
introduced a 2M(SUBSECTION_SIZE) hot plug granule, which disrupted the
existing arm64 assumptions.
Considering the vmemmap_free -> unmap_hotplug_pmd_range path, when
pmd_sect() is true, the entire PMD section is cleared, even if there is
other effective subsection. For example page_struct_map1 and
page_strcut_map2 are part of a single PMD entry and they are hot-added
sequentially. Then page_struct_map1 is removed, vmemmap_free() will clear
the entire PMD entry freeing the struct page map for the whole section,
even though page_struct_map2 is still active. Similar problem exists
with linear mapping as well, for 16K base page(PMD size = 32M) or 64K
base page(PMD = 512M), their block mappings exceed SUBSECTION_SIZE.
Tearing down the entire PMD mapping too will leave other subsections
unmapped in the linear mapping.
To address the issue, we need to prevent PMD/PUD/CONT mappings for both
linear and vmemmap for non-boot sections if corresponding size on the
given base page exceeds SUBSECTION_SIZE(2MB now).
Cc: <stable@vger.kernel.org> # v5.4+
Fixes: ba72b4c8cf60 ("mm/sparsemem: support sub-section hotplug")
Reviewed-by: Catalin Marinas <catalin.marinas@arm.com>
Signed-off-by: Zhenhua Huang <quic_zhenhuah@quicinc.com>
---
arch/arm64/mm/mmu.c | 46 ++++++++++++++++++++++++++++++++++++---------
1 file changed, 37 insertions(+), 9 deletions(-)
diff --git a/arch/arm64/mm/mmu.c b/arch/arm64/mm/mmu.c
index b4df5bc5b1b8..b1089365f3e7 100644
--- a/arch/arm64/mm/mmu.c
+++ b/arch/arm64/mm/mmu.c
@@ -42,9 +42,13 @@
#include <asm/pgalloc.h>
#include <asm/kfence.h>
-#define NO_BLOCK_MAPPINGS BIT(0)
-#define NO_CONT_MAPPINGS BIT(1)
-#define NO_EXEC_MAPPINGS BIT(2) /* assumes FEAT_HPDS is not used */
+#define NO_PMD_BLOCK_MAPPINGS BIT(0)
+#define NO_PUD_BLOCK_MAPPINGS BIT(1) /* Hotplug case: do not want block mapping for PUD */
+#define NO_BLOCK_MAPPINGS (NO_PMD_BLOCK_MAPPINGS | NO_PUD_BLOCK_MAPPINGS)
+#define NO_PTE_CONT_MAPPINGS BIT(2)
+#define NO_PMD_CONT_MAPPINGS BIT(3) /* Hotplug case: do not want cont mapping for PMD */
+#define NO_CONT_MAPPINGS (NO_PTE_CONT_MAPPINGS | NO_PMD_CONT_MAPPINGS)
+#define NO_EXEC_MAPPINGS BIT(4) /* assumes FEAT_HPDS is not used */
u64 kimage_voffset __ro_after_init;
EXPORT_SYMBOL(kimage_voffset);
@@ -224,7 +228,7 @@ static void alloc_init_cont_pte(pmd_t *pmdp, unsigned long addr,
/* use a contiguous mapping if the range is suitably aligned */
if ((((addr | next | phys) & ~CONT_PTE_MASK) == 0) &&
- (flags & NO_CONT_MAPPINGS) == 0)
+ (flags & NO_PTE_CONT_MAPPINGS) == 0)
__prot = __pgprot(pgprot_val(prot) | PTE_CONT);
init_pte(ptep, addr, next, phys, __prot);
@@ -254,7 +258,7 @@ static void init_pmd(pmd_t *pmdp, unsigned long addr, unsigned long end,
/* try section mapping first */
if (((addr | next | phys) & ~PMD_MASK) == 0 &&
- (flags & NO_BLOCK_MAPPINGS) == 0) {
+ (flags & NO_PMD_BLOCK_MAPPINGS) == 0) {
pmd_set_huge(pmdp, phys, prot);
/*
@@ -311,7 +315,7 @@ static void alloc_init_cont_pmd(pud_t *pudp, unsigned long addr,
/* use a contiguous mapping if the range is suitably aligned */
if ((((addr | next | phys) & ~CONT_PMD_MASK) == 0) &&
- (flags & NO_CONT_MAPPINGS) == 0)
+ (flags & NO_PMD_CONT_MAPPINGS) == 0)
__prot = __pgprot(pgprot_val(prot) | PTE_CONT);
init_pmd(pmdp, addr, next, phys, __prot, pgtable_alloc, flags);
@@ -358,8 +362,8 @@ static void alloc_init_pud(p4d_t *p4dp, unsigned long addr, unsigned long end,
* For 4K granule only, attempt to put down a 1GB block
*/
if (pud_sect_supported() &&
- ((addr | next | phys) & ~PUD_MASK) == 0 &&
- (flags & NO_BLOCK_MAPPINGS) == 0) {
+ ((addr | next | phys) & ~PUD_MASK) == 0 &&
+ (flags & NO_PUD_BLOCK_MAPPINGS) == 0) {
pud_set_huge(pudp, phys, prot);
/*
@@ -1178,7 +1182,13 @@ int __meminit vmemmap_populate(unsigned long start, unsigned long end, int node,
{
WARN_ON((start < VMEMMAP_START) || (end > VMEMMAP_END));
- if (!IS_ENABLED(CONFIG_ARM64_4K_PAGES))
+ /*
+ * Hotplugged section does not support hugepages as
+ * PMD_SIZE (hence PUD_SIZE) section mapping covers
+ * struct page range that exceeds a SUBSECTION_SIZE
+ * i.e 2MB - for all available base page sizes.
+ */
+ if (!IS_ENABLED(CONFIG_ARM64_4K_PAGES) || system_state != SYSTEM_BOOTING)
return vmemmap_populate_basepages(start, end, node, altmap);
else
return vmemmap_populate_hugepages(start, end, node, altmap);
@@ -1340,9 +1350,27 @@ int arch_add_memory(int nid, u64 start, u64 size,
struct mhp_params *params)
{
int ret, flags = NO_EXEC_MAPPINGS;
+ unsigned long start_pfn = PFN_DOWN(start);
+ struct mem_section *ms = __pfn_to_section(start_pfn);
VM_BUG_ON(!mhp_range_allowed(start, size, true));
+ /* should not be invoked by early section */
+ WARN_ON(early_section(ms));
+
+ /*
+ * Disallow BLOCK/CONT mappings if the corresponding size exceeds
+ * SUBSECTION_SIZE which now is 2MB.
+ *
+ * PUD_BLOCK or PMD_CONT should consistently exceed SUBSECTION_SIZE
+ * across all variable page size configurations, so add them directly
+ */
+ flags |= NO_PUD_BLOCK_MAPPINGS | NO_PMD_CONT_MAPPINGS;
+ if (SUBSECTION_SHIFT < PMD_SHIFT)
+ flags |= NO_PMD_BLOCK_MAPPINGS;
+ if (SUBSECTION_SHIFT < CONT_PTE_SHIFT)
+ flags |= NO_PTE_CONT_MAPPINGS;
+
if (can_set_direct_map())
flags |= NO_BLOCK_MAPPINGS | NO_CONT_MAPPINGS;
--
2.25.1
next reply other threads:[~2025-02-13 7:57 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-02-13 7:57 Zhenhua Huang [this message]
2025-02-13 12:59 ` David Hildenbrand
2025-02-13 15:49 ` Catalin Marinas
2025-02-13 16:16 ` David Hildenbrand
2025-02-13 17:56 ` Catalin Marinas
2025-02-13 18:20 ` David Hildenbrand
2025-02-14 9:46 ` Zhenhua Huang
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20250213075703.1270713-1-quic_zhenhuah@quicinc.com \
--to=quic_zhenhuah@quicinc.com \
--cc=akpm@linux-foundation.org \
--cc=anshuman.khandual@arm.com \
--cc=ardb@kernel.org \
--cc=catalin.marinas@arm.com \
--cc=chenfeiyang@loongson.cn \
--cc=chenhuacai@kernel.org \
--cc=dave.hansen@linux.intel.com \
--cc=joey.gouly@arm.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mm@kvack.org \
--cc=mark.rutland@arm.com \
--cc=quic_tingweiz@quicinc.com \
--cc=ryan.roberts@arm.com \
--cc=stable@vger.kernel.org \
--cc=will@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox