Re: [PATCH v12 20/22] x86/virt/tdx: Allow SEAMCALL to handle #UD and #GP

[Peter Zijlstra <peterz@infradead.org>]

On Tue, Jun 27, 2023 at 02:12:50AM +1200, Kai Huang wrote:
> diff --git a/arch/x86/virt/vmx/tdx/tdxcall.S b/arch/x86/virt/vmx/tdx/tdxcall.S
> index 49a54356ae99..757b0c34be10 100644
> --- a/arch/x86/virt/vmx/tdx/tdxcall.S
> +++ b/arch/x86/virt/vmx/tdx/tdxcall.S
> @@ -1,6 +1,7 @@
>  /* SPDX-License-Identifier: GPL-2.0 */
>  #include <asm/asm-offsets.h>
>  #include <asm/tdx.h>
> +#include <asm/asm.h>
>  
>  /*
>   * TDCALL and SEAMCALL are supported in Binutils >= 2.36.
> @@ -45,6 +46,7 @@
>  	/* Leave input param 2 in RDX */
>  
>  	.if \host
> +1:
>  	seamcall

So what registers are actually clobbered by SEAMCALL ? There's a
distinct lack of it in SDM Vol.2 instruction list :-(

>  	/*
>  	 * SEAMCALL instruction is essentially a VMExit from VMX root
> @@ -57,10 +59,23 @@
>  	 * This value will never be used as actual SEAMCALL error code as
>  	 * it is from the Reserved status code class.
>  	 */
> -	jnc .Lno_vmfailinvalid
> +	jnc .Lseamcall_out
>  	mov $TDX_SEAMCALL_VMFAILINVALID, %rax
> -.Lno_vmfailinvalid:
> +	jmp .Lseamcall_out
> +2:
> +	/*
> +	 * SEAMCALL caused #GP or #UD.  By reaching here %eax contains
> +	 * the trap number.  Convert the trap number to the TDX error
> +	 * code by setting TDX_SW_ERROR to the high 32-bits of %rax.
> +	 *
> +	 * Note cannot OR TDX_SW_ERROR directly to %rax as OR instruction
> +	 * only accepts 32-bit immediate at most.
> +	 */
> +	mov $TDX_SW_ERROR, %r12
> +	orq %r12, %rax
>  
> +	_ASM_EXTABLE_FAULT(1b, 2b)
> +.Lseamcall_out:

This is all pretty atrocious code flow... would it at all be possible to
write it like:

SYM_FUNC_START(...)

.if \host
1:	seamcall
	cmovc	%spare, %rax
2:
.else
	tdcall
.endif

	.....
	RET


3:
	mov $TDX_SW_ERROR, %r12
	orq %r12, %rax
	jmp 2b

	_ASM_EXTABLE_FAULT(1b, 3b)

SYM_FUNC_END()

That is, having all that inline in the hotpath is quite horrific.