Hi.

I don't seem to be able to type anything on the keyboard in 2.6.2-rc1-mm2. It
works fine in -rc1-mm1. There are a few differences in dmesg output of mm2
compared to mm1.

BogoMIPS is figured out to be 8.19 (this was already reported by another user),
and i8042.c complaints with this:
i8042.c: Can't write CTR while closing AUX.

After browsing through the dmesg output, I noticed this one:
hub 3-0:1.0: Cannot enable port 2.  Maybe the USB cable is bad?

Normally (ie. in -mm1 and below) it reads:
hub 3-0:1.0: new USB device on port 2, assigned address 2

The full output is attached, of course.

Is there a patch I should try to revert, Andrew?

Thanks,
  Rudo.