From: Miquel van Smoorenburg <mikevs@xs4all.net>
To: Andrew Morton <akpm@linux-foundation.org>
Cc: Andi Kleen <andi@firstfloor.org>,
Glauber Costa <gcosta@redhat.com>,
linux-kernel@vger.kernel.org, linux-mm@kvack.org,
Ingo Molnar <mingo@elte.hu>
Subject: Re: [PATCH] 2.6.26-rc: x86: pci-dma.c: use __GFP_NO_OOM instead of __GFP_NORETRY
Date: Tue, 27 May 2008 11:35:06 +0200 [thread overview]
Message-ID: <1211880906.23541.41.camel@localhost.localdomain> (raw)
In-Reply-To: <20080527014720.6db68517.akpm@linux-foundation.org>
On Tue, 2008-05-27 at 01:47 -0700, Andrew Morton wrote:
> On Tue, 27 May 2008 01:49:47 +0200 Miquel van Smoorenburg <mikevs@xs4all.net> wrote:
>
> > Please consider the below patch for 2.6.26 (can somebody from the
> > x86 team pick this up please? Thank you)
> >
> >
> >
> > [PATCH] 2.6.26-rc: x86: pci-dma.c: use __GFP_NO_OOM instead of __GFP_NORETRY
> >
> > arch/x86/kernel/pci-dma.c::dma_alloc_coherent() adds __GFP_NORETRY to
> > the gfp flags before calling alloc_pages() to prevent the oom killer
> > from running.
>
> Now, why does dma_alloc_coherent() do that?
>
> If __GFP_FS is cleared (most cases) then we won't be calling
> out_of_memory() anyway.
>
> If __GFP_FS _is_ set then setting __GFP_NORETRY will do much more than
> avoiding oom-killings. It will prevent the page allocator from
> retrying and will cause the problems which one assumes (without
> evidence :() you have observed.
Ah right, this was discussed in a different thread on linux-kernel /
linux-mm. Message id <20080521113028.GA24632@xs4all.net> or see
http://lkml.org/lkml/2008/5/21/131
> So... why not just remove the setting of __GFP_NORETRY? Why is it
> wrong to oom-kill things in this case?
This was the first thing I proposed, since it was already that way in
pci-dma_32.c, the __GFP_NORETRY was only added in pci-dma_64.c . Hence I
found out about this when moving boxes to a 64 bit kernel. But in
2.6.26, those two were merged.
>
> > This has the expected side effect that that alloc_pages() doesn't
> > retry anymore. Not really a problem for dma_alloc_coherent(.. GFP_ATOMIC)
> > which is the way most drivers use it (through pci_alloc_consistent())
> > but drivers that call dma_alloc_coherent(.. GFP_KERNEL) directly can get
> > unexpected failures.
> >
> > Until we have the mask allocator, use a new flag __GFP_NO_OOM
> > instead of __GFP_NORETRY.
> >
>
> But this change increases the chances of a caller getting stuck in the
> page allocator for ever, unable to make progress?
Another bandaid fix I proposed was this:
diff -ruN linux-2.6.26-rc3.orig/arch/x86/kernel/pci-dma.c linux-2.6.26-rc3/arch/x86/kernel/pci-dma.c
--- linux-2.6.26-rc3.orig/arch/x86/kernel/pci-dma.c 2008-05-18 23:36:41.000000000 +0200
+++ linux-2.6.26-rc3/arch/x86/kernel/pci-dma.c 2008-05-22 21:21:37.000000000 +0200
@@ -398,7 +398,8 @@
return NULL;
/* Don't invoke OOM killer */
- gfp |= __GFP_NORETRY;
+ if (!(gfp & __GFP_WAIT))
+ gfp |= __GFP_NORETRY;
#ifdef CONFIG_X86_64
/* Why <=? Even when the mask is smaller than 4GB it is often
This will at least make sure that when called with GFP_KERNEL, __GFP_NORETRY
is not set, while it will be set with GFP_ATOMIC.
But I concluded from the earlier discussion that there was consensus about
__GFP_NO_OOM , so I sent this patch. Now I'm most definitely not an
expert, in fact pretty ignorant really, so if there are serious objections
or a better solution, please drop this patch.
I do think the issue should still be fixed.
The minimum would be to surround the gfp |= __GFP_NORETRY with
#ifdef CONFIG_X86_64 so that at least 32 bit doesn't regress
in 2.6.26
However as dpt_i2o in 2.6.26 works on 64 bit systems now and
it calls dma_alloc_coherent(.. GFP_KERNEL) I'm afraid it might
cause instability with that driver on x86_64 (that's my main
worry. tw_cli crashing is merely inconvenient).
Mike.
--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@kvack.org. For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>
next prev parent reply other threads:[~2008-05-27 9:35 UTC|newest]
Thread overview: 9+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-05-26 23:49 Miquel van Smoorenburg
2008-05-27 8:03 ` Ingo Molnar
2008-05-27 8:47 ` Andrew Morton
2008-05-27 9:35 ` Miquel van Smoorenburg [this message]
2008-05-28 2:47 ` Andi Kleen
2008-05-28 8:31 ` Miquel van Smoorenburg
2008-05-28 8:40 ` Andrew Morton
2008-05-28 12:54 ` Andi Kleen
2008-06-02 10:15 ` Ingo Molnar
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1211880906.23541.41.camel@localhost.localdomain \
--to=mikevs@xs4all.net \
--cc=akpm@linux-foundation.org \
--cc=andi@firstfloor.org \
--cc=gcosta@redhat.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mm@kvack.org \
--cc=mingo@elte.hu \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox